3-Hour Fast Charger 67.2V 10A Raptor2

⚠️ Compatibility Notice: This charger is designed exclusively for the YUME Raptor2. It is NOT compatible with any other YUME scooter models.

🚚 PRE-ORDER — Estimated Shipping: Mid September

YUME Raptor2 67.2V 10A Fast Charger

Charge your Raptor2 faster and spend less time waiting. The 67.2V 10A Fast Charger can fully charge the Raptor2 in approximately 3 hours, making it ideal when you need to get back on the road sooner.

⚠️ Important Charging Limit

The Raptor2 supports a maximum total charging current of 10A.

When using this 10A charger:

• Use only one 10A charger at a time.
• DO NOT connect two 10A chargers simultaneously.
• Do not use another charger through the second charging port while the 10A charger is connected.

Exceeding the supported 10A charging current may damage the battery or charging system.

Built-In Charging Protection

The charger includes built-in protection systems designed to help protect the charger and battery during normal use:

• Overload protection
• Over-voltage protection
• Under-voltage protection
• Short-circuit protection

Charging Status Indicator

The built-in LED indicator makes it easy to check the charging status:

• Red Light: Charging
• Green Light: Fully charged

Once the battery reaches full charge, the charger automatically stops charging.

Active Cooling System

An integrated cooling fan helps dissipate heat and keeps the charger operating at a suitable temperature during high-current charging. This supports stable charging performance and helps extend the charger’s service life.

Important Notes

• Designed exclusively for the YUME Raptor2 67.2V charging system.
• Not compatible with other YUME scooter models.
• The charger is not waterproof. Keep it dry during use and storage.
• Always charge in a dry, well-ventilated area.
• Do not cover the charger while it is operating.
• Do not use the charger if the charger, cable, plug, or scooter charging port appears damaged.
• Maximum supported charging current for the Raptor2: 10A total.

Recommended Charging Procedure

1. Connect the charger to the Raptor2 charging port.
2. Connect the charger to the AC power outlet.
3. Allow the battery to charge until the indicator turns green.
4. Disconnect the charger from the AC power outlet first.
5. Then disconnect the charger from the scooter.