6-Hour Fast Charger 67.2V 5A Raptor2

⚠️ Compatibility Notice: This charger is designed exclusively for the YUME Raptor2. It is NOT compatible with any other YUME scooter models.

🚚 PRE-ORDER — Estimated Shipping: Early September

YUME Raptor2 67.2V 5A Charger

The 67.2V 5A Charger provides reliable and efficient charging for the YUME Raptor2.

Charging Time

• 1 × 5A charger: Approximately 5–6 hours for a full charge
• 2 × 5A chargers: Approximately 3 hours for a full charge
• 1 × 10A charger: Approximately 3 hours for a full charge

For faster charging, you can use either two 5A chargers simultaneously or a single 10A Fast Charger. One 10A charger provides the same total charging current as two 5A chargers while requiring only one charger.

Click here to purchase the Raptor2 10A Fast Charger:https://www.yumescooter.com/products/fast-charger-67-2v-10a-raptor2

⚠️ Important Charging Limit

The Raptor2 supports a maximum total charging current of 10A. You may use:

• 1 × 5A charger
• 2 × 5A chargers simultaneously
• 1 × 10A charger

DO NOT use two 10A chargers at the same time. Exceeding the supported 10A charging current may damage the battery or charging system.

Built-In Charging Protection

The charger includes built-in protection systems designed to help protect the charger and battery during normal use:

• Overload protection
• Over-voltage protection
• Under-voltage protection
• Short-circuit protection

Charging Status Indicator

The built-in LED indicator makes it easy to check the charging status:

• Red Light: Charging
• Green Light: Fully charged

Once the battery reaches full charge, the charger automatically stops charging.

Active Cooling System

An integrated cooling fan helps dissipate heat during charging and keeps the charger operating at a suitable temperature. This supports stable charging performance and helps extend the charger’s service life.

Important Notes

• Designed exclusively for the YUME Raptor2 67.2V charging system.
• Not compatible with other YUME scooter models.
• The charger is not waterproof. Keep it dry during use and storage.
• Always charge in a dry, well-ventilated area.
• Do not cover the charger while it is operating.
• Do not use the charger if the charger, cable, plug, or scooter charging port appears damaged.
• Maximum supported charging current for the Raptor2: 10A total.

Recommended Charging Procedure

1. Connect the charger to the Raptor2 charging port.
2. Connect the charger to the AC power outlet.
3. Allow the battery to charge until the indicator turns green.
4. Disconnect the charger from the AC power outlet first.
5. Then disconnect the charger from the scooter.

When using two 5A chargers, connect one charger to each charging port. The combined charging current must not exceed 10A.